When heavy rear components such as suspension, fuel tank, spare
tire, tailgate and trunk lid are to be removed, place additional weight
in the luggage area before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change and can
cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as shown in the
illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock the vehicle
to be sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift points for
secure support.
|
Manual climate control system
1. Turn the ignition switch to the ON position. 2. Select the defrost button
(). 3. Press the air intake control
button at least 5 times within 3 seconds.
The indicator on the air intake button ...
Shift Lever. Repair procedures
Removal
Shift Lever Assembly
Replacement
1.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
...
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...