Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
3. |
Disconnect the injector connector (A).
|
4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
Installation
|
1. |
Installation is reverse of removal.
|
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Excessive turning resistance of lower ar ...
Instrument panel illumination
Press the illumination control switch to adjust the instrument panel illumination
intensity. For instrument cluster type A, the vehicle’s parking lights or headlights
should be on to adjust th ...
Child restraint system
Children riding in the car should sit in the rear seat and must always be properly
restrained to minimize the risk of injury in an accident, sudden stop or sudden
maneuver. According to accident s ...