Hyundai Veloster Manuals

Hyundai Veloster: Introduction - If you have a flat tire (with tire mobility kit) - What to do in an emergencyHyundai Veloster: Introduction

With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture.

With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture.

The system of compressor and sealing compound effectively and comfortably seals most punctures in a passenger car tire caused by nails or similar objects and reinflates the tire.

After you ensured that the tire is properly sealed you can drive cautiously on the tire (up to 120 miles (200 km)) at a max. speed of 50 mph (80 km/h) in order to reach a vehicle or tire dealer to have the tire replaced.

It is possible that some tires, especially with larger punctures or damage to the sidewall, cannot be sealed completely.

Air pressure loss in the tire may adversely affect tire performance.

For this reason, you should avoid abrupt steering or other driving maneuvers, especially if the vehicle is heavily loaded or if a trailer is in use.

The Tire Mobility Kit is not designed or intended as a permanent tire repair method and is to be used for one tire only.

This instruction shows you step by step how to temporarily seal the puncture simply and reliably.

Read the section "Notes on the safe use of the Tire Mobility Kit".

WARNING

If you have a flat tire (with tire mobility kit)
Please read the instructions before using the Tire Mobility Kit. (1) Compressor (2) Sealant bottle WARNING For safe operation, carefully read and follow the instructions in this manual before u ...

Notes on the safe use of the Tire Mobility Kit
Park your car at the side of the road so that you can work with the Tire Mobility Kit away from moving traffic. Place your warning triangle in a prominent place to make passing vehicles aware ...

See also:

Seat Heater. Repair procedures
Inspection First Seat Heater 1. Check for continuity and measure the resistance between terminals. [Cushion] No. ...

Seat Belt Pretensioner (BPT). Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the lower anchor b ...

System operation
Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed contr ...

Categories


В© 2011-2024 Copyright www.hvmanual.com