Replacement
|
1. |
After loosening the hood hinge (A) mounting bolts,
and then remove the hood (B).
|
2. |
Installation is the reverse of removal.
|
1. |
Using a clip remover, detach the clips, and remove
the hood insulator pad (A).
|
2. |
Installation is the reverse of removal.
|
1. |
Remove the hood weatherstrip (A).
|
2. |
Installation is the reverse of removal.
|
1. |
Using a screwdriver or remover, remove the hood latch
release handle (A).
|
2. |
Installation is the reverse of removal.
|
1. |
Remove the hood latch (A) mounting bolts.
|
2. |
Disconnect the hood latch release handle cable (A)
and remove the hood latch (B).
|
3. |
Installation is the reverse of removal.
|
Adjustment
1. |
After loosening the hinge (A) mounting bolt, adjust
the hood (B) by moving it front or rear, or right or left.
|
2. |
Adjust the hood height by turning the hood over slam
bumpers (C).
|
3. |
After loosening the hood latch (D) mounting bolts
and nuts, adjust the latch by moving it up or down, or right or left.
|
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the
shift lever to the P(Park) pos ...
Clutch Pedal. Repair procedures
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin pla ...
Description and Operation
Description
Mobile Telemetics System (MTS)
Hyundai motor companies are now faced with the task of shifting their
paradigm from vehicle-centered services to customer valuecentered services, ...