Inspection
1. |
The GDS will be able to diagnose defects of hazard switch quickly.
The GDS can operates actuator manually, input/output value monitoring
and self diagnosis.
|
2. |
Select model and "BCM".
|
3. |
Select the "SJB" to check.
|
4. |
Select "Current data", if you will check current data of hazard
switch. It provides input/output status of SJB.
|
Removal
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the heater control module.
(Refer to the HA group - "Controller")
|
Installation
1. |
Install the heater control module.
(Refer to the HA group - "Controller")
|
Tailgate room lamp
The tailgate room lamp comes on when the tailgate is opened.
CAUTION
The tailgate room lamp comes on as long as the tailgate lid opens. To prevent
unnecessary charging system drain, close the ta ...
To connect using the unit settings (2)
1. Press on the control panel.
2. Press [Search for Bluetooth devices].
NOTE:
If you touch on the control panel
again after connected via Bluetooth wireless technology, the Bluetooth main scr ...
Theft-alarm stage
The alarm will be activated if any of the following occurs while the system is
armed.
A door is opened without using the transmitter (or smart key or mechanical
key).
The trunk is opened wi ...