Hyundai Veloster Manuals

Hyundai Veloster: Hands Free Switch. Repair procedures - Hands Free System - Body Electrical SystemHyundai Veloster: Hands Free Switch. Repair procedures

Inspection

1.
Check the hands free remote control switch for resistance between terminals in each switch position.

Switch
Connector terminal
Resistance
(В±5%)
Voice
3 - 4
10.71 kΩ
End of call
3 - 4
18.91 kΩ
Send
3 - 4
40.91 kΩ


Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove th driver airbag module.
(Refer to the RT group - "Driver airbag(DAB) and clock spring)
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column and shaft")
4.
Remove the cover(A) after loosening screws.

5.
Disconnector the left audio switch (A).

6.
Disconnector the right hands free switch and trip switch (A).

7.
Remove the wiring (A) then loosening 5 screws.

8.
Remove the steering wheel remote control switchs assembly (A).


Installation

1.
Install the hands free switch to the steering wheel.
2.
Install the steering wheel cover.
3.
Install the steering wheel.
4.
Reassemble the driver airbag module.
Make sure the hands free remote control switch and the airbag module connectors are plugged in properly.

Hands Free Switch. Schematic Diagrams
Circuit Diagram ...

Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

See also:

Indicator symbols on the instrument cluster
...

Intake Air Temperature Sensor (IATS). Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction o ...

Rear combination lamp. Repair procedures
Removal Rear Combination lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after loosening 2 screws, an ...

Categories


В© 2011-2024 Copyright www.hvmanual.com