Removal
1. |
Remove the following parts first:
|
2. |
Place the shift lever in the N position.
|
3. |
Disconnect the shift actuator connector (A) and select actuator
connector (B), and then remove the wire fixing clip.
|
4. |
Loosen the mounting bolt, and then remove the gear actuator (A).
|
Installation
1. |
Installation is the reverse of removal.
|
Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. To improve the
effectiveness of heating and cooling : - Heating:
- Cooling: 3. Set the temperature
control to the desired position. ...
Side Impact Sensor (SIS). Repair procedures
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remo ...
CVVT Oil Control Valve (OCV). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the ...