Hyundai Veloster: Fuel Tank Air Filter. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter. Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Lift the vehicle.

3.	Disconnect the canister close valve connector (A).

4.	Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.

5.	Remove the fuel tank air filter assembly after removing bolts (C).

6.	Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

1.	Installation is reverse of removal.

Fuel Filler Cap. Description and Operation

Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

Exhaust Emission Control System

...

See also:

Cup holder
WARNING - Hot liquids • Do not place uncovered cups of hot liquid in the cup holder while the vehicle is in motion. If the hot liquid spills, you may burn yourself. Such a burn to the driv ...

Purge Control Solenoid Valve (PCSV). Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when ...

Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating positions. The indications of the system's pr ...

Categories

© 2011-2026 Copyright www.hvmanual.com