Removal
1. |
Release the residual pressure in fuel line (Refer to “Release
Residual Pressure in Fuel Line” in this group).
|
2. |
Remove the rear seat [LH] (Refer to “Seat” in BD group).
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A).
|
5. |
Disconnect the fuel feed tube quick connector (B).
|
6. |
Disconnect the fuel tank pressure sensor connector (C).
|
7. |
Disconnect the vapor tube quick-connector (D).
|
8. |
Remove the plate cover (E) after removing the installation bolts,
and then remove the fuel pump from the fuel tank.
|
Installation
1. |
Installation is reverse of removal.
|
Inspection
[Fuel pump]
1. |
Turn ignition switch OFF and disconnect the negative (-)battery
cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Check motor operation by fuel pump connector (A) connecting power(No.2)
and ground(No.4)
|
[Fuel sender]
1. |
Using an ohmmeter, measure the resistance between terminals 1
and 3 of sender connector (A) at each float level.
|
2. |
Also check that the resistance changes smoothly when the float
is moved from "E" to "F".
|
Front Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper body
4. Caliper carrier
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Smart key unit. Repair procedures
Inspection
Smart Key Unit
-
Refer to the BE group - inspection / self diagnosis with GDS.
Smart Key Switch
-
Refer to the BE group - inspecti ...
Instrument Cluster. Components and Components Location
Components
...