Replacement
1. |
Remove the fuel pump (Refer to “Fuel Pump” in this group).
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel
sender connector (B).
|
3. |
Remove the head assembly (A) after releasing the cushion fixing
clip (B).
|
4. |
Disconnect the fuel tube quick-connectors (C).
|
5. |
Remove the fuel sender (A) in the direction of an arrow.
|
6. |
Disconnect the fuel tube connector (A).
|
7. |
Remove the ORVR valve (A) after releasing hooks (B).
|
8. |
Remove the reservior-cup (B) after releasing the fixing hooks
(A).
|
9. |
Release the fixing hooks, and then remove the pre-filter (A) and
the fuel pressure regulator (B).
|
10. |
Replace new fuel filter.
1. Head assembly
2. Electric pump motor
3. Fuel filter
4. Fuel sender
5. Fuel pressure regulator
6. Pre-filter
7. Reservoir cup
8. ORVR valve
|
Power Seat Control Switch. Repair procedures
Inspection
1.
With the lumbar support switch (A) in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, re ...
Accelerator Position Sensor (APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important senso ...
Description and Operation
Operation and Leakage Check
Check all of the following items:
Component
Procedure
Brake Booster (A)
Check brake operation by applyin ...