Hyundai Veloster Manuals

Hyundai Veloster: Front Wiper Motor. Repair procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Veloster: Front Wiper Motor. Repair procedures

Removal

1.
Remove the passenger cowl top cover (A) to remove passenger wiper blade.

2.
Loosen the windshield wiper arm nut (B) after removing a wiper cap (A).

3.
Remove the windshield wiper arm and blade.
4.
If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm.

5.
Disconnect the washer hose (A) connected to cowl top cover.

6.
Remove the weather strip and the cowl top cover (A) after removing 4 rivets.

7.
Disconnect the wiper motor connector from the wiper motor & linkage assembly.
8.
Remove the windshield wiper motor and linkage assembly (A) after removing 2 bolts.

9.
Hold the wiper motor crank arm and remove the upper linkage (A) from the wiper motor crank arm.

Before removing the wiper motor and linkage assembly, make sure that the linkage is stopped at auto stop position.
To install the wiper motor crank arm exactly, check that the linkage is aligned with the crank arm in straight line and the angle of each linkages.
Be careful not to bend the linkage.
10.
Remove the lower linkage (A) from the wiper motor crank arm.

11.
Remove the wiper motor crank arm (A), after loosening the nut.

12.
Remove the wiper motor(A), after loosening 3 bolts.


Installation

1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the linkage to the wiper motor crank arm.
To install the wiper motor crank arm (A), make sure that the linkage (B) is aligned with the crank arm in straight line and set the angle of each linkages exactly.
Be careful not to bend the linkage.

4.
Install the wiper motor and linkage assembly and then connect the wiper motor connector.

Tightening torque:
6.9 ~ 10.8Nm (0.7 ~ 1.1, kgf.m, 5.1 ~ 8.0 lb-ft)

5.
Install the cowl top cover.
6.
Install the windshield wiper arm and blade.

Tightening torque:
22.5 ~ 26.5 Nm (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.6 lb-ft)

-
The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
If necessary, adjust the wiper arm and blade.
7.
Install the wiper arm and blade to the auto stop position.
A : Auto stop position (Blade)

8.
Set the cowl top cover on the specified spray position.
-
When you turn on the washer, confirm 50% or more of washer fluid lands within the spray area.
-
If the spray area is not within the standard positions, adjust the nozzle(s).

Specified position
Distance (in)
Distance (mm)
A
9.88
251
B
15.51
394
C
18.94
481
D
19.33
491
E
2.48
63
F
1.67
42.5
G
18.09
459.5
H
18.82
478


Inspection

Speed Operation Check
1.
Remove the connector (A) from the wiper motor.

Pin No.
Description
1
Ground
2
Parking
3
Battery
4
Low
5
High

2.
Attach the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 1.
3.
Check that the motor operates at low or high speed as below table.

Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.

Front Wiper Motor. Components and Components Location
Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Cowl top cover 5. Bolt 6. Wiper motor & linkage assembly ...

Front Washer Motor. Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

See also:

Master Cylinder. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery (A) and ECM (B). (Refer ...

Anchor Pretensioner (APT). Components and Components Location
Components ...

Parking brake
Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone ...

Categories


© 2011-2024 Copyright www.hvmanual.com