Hyundai Veloster Manuals

Hyundai Veloster: Front Repair procedures - Bumper - Body (Interior and Exterior)Hyundai Veloster: Front Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body (Interior and Exterior) / Bumper / Front Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips.
2.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
3.
Remove the front bumper lower mounting clips.
4.
Disconnect the fog lamp connector (A).
5.
Remove the front bumper.
6.
Installation is the reverse of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.

Front Components and Components Location
Components-1 1. Front bumper cover 2. Front bumper side bracket [LH] 3. Front bumper side bracket [RH] Components-2 (T-GDI) 1. Front b ...

Rear Components and Components Location
Components-1 1. Rear bumper cover 2. Tail trim lower cover 3. Rear bumper side bracket [RH] 4. Rear bumper side bracket [LH] Components-2 (T-GDI) ...

See also:

Repair procedures
Troubleshooting Starter Circuit The battery must be in good condition and fully charged. 1. Remove ...

Specifications
Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 22.0 ~ 26.0 [20°C( ...

1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase th ...

Categories


© 2011-2024 Copyright www.hvmanual.com