Hyundai Veloster Manuals

Hyundai Veloster: Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Veloster: Front Impact Sensor (FIS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Depowered) / SRSCM / Front Impact Sensor (FIS). Repair procedures

Removal

•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front wheel guard.
3.
Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
4.
Remove the front impact sensor mounting bolt (B).
5.
Disconnect the front impact sensor connector (A).
6.
Remove the front impact sensor.

Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front wheel guard.
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS). Components and Components Location
Components ...

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

See also:

Components of the Tire Mobility Kit
0. Speed restriction label 1. Sealant bottle and label with speed restriction 2. Filling hose from sealant bottle to wheel 3. Connectors and cable for the power outlet direct connection 4. Holde ...

Passenger Airbag (PAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the glove box housin ...

Rail Pressure Sensor (RPS). Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built ...

Categories


© 2011-2024 Copyright www.hvmanual.com