Replacement
|
1. |
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
|
2. |
Remove the head lamps.
(Refer to the BE group – “Head Lamps”)
|
3. |
Loosen the mud guard (A) mounting screws and clips.
|
4. |
To remove the A pillar garnish (A), loosen the mounting
screw after removing the cap (B).
|
5. |
Detach the clip and then remove the fender side cover
(A).
|
6. |
Detach the clips and then remove the insulator pad
(A).
|
7. |
After loosening the mounting screws and bolt, then
remove the front bumper side mounting bracket (A).
|
8. |
After loosening the mounting bolts and nut, then
remove the fender (A).
|
9. |
Installation is the reverse of removal.
|
Winter driving
More severe weather conditions of winter result in greater wear and other problems.
To minimize winter driving problem, you should follow these suggestions:
Snowy or icy conditions
To drive your ...
Accelerator Position Sensor (APS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the ...
Head Lamps. Components and Components Location
Component
1. Head lamp assembly lens & housing
2. Head lamp (Low) lamp
3. Dust cover (Low)
4. Turn signal lamp
5. Head lamp (High) lamp
6. Dust cover (Hi ...