Hyundai Veloster Manuals

Hyundai Veloster: ETC (Electronic Throttle Control) System. Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: ETC (Electronic Throttle Control) System. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Repair procedures

Inspection

Throttle Position Sensor (TPS)

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
 Output Voltage (V)
TPS1
 TPS2
C.T
 0.5
 4.5
W.O.T
 4.41
 0.59

ETC Motor

1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ETC module connector (A).
4.
Remove the installation bolts, and then remove the ETC module (A) from the engine.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Adjustment

ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at th IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.

ETC (Electronic Throttle Control) System. Schematic Diagrams
Circuit Diagram ...

Manifold Absolute Pressure Sensor (MAPS). Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog ...

See also:

Rear Hub - Carrier. Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and ...

Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment. When you have new tires instal ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Categories

© 2011-2026 Copyright www.hvmanual.com