Removal
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
[In the case of installing used ECM]
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
Then the ECM key register process is completed automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the ECM Connector (A).
|
3. |
Remove the battery (Refer to "Charging System" in EM group).
|
4. |
Remove the mounting bolts and nut, and then remove the ECM bracket
assembly (A).
|
5. |
Remove the ECM (B) after removing 4 nuts (A) from the bracket.
|
Installation
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
[In the case of installing used ECM]
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
Then the ECM key register process is completed automatically.
|
1. |
Installation is reverse of removal.
|
ECM Problem Inspection Procedure
1. |
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is found, repair it.
|
2. |
TEST ECM CONNECTOR: Disconnect the ECM connector and visually
check the ground terminals on ECM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it.
|
3. |
If problem is not found in Step 1 and 2, the ECM could be faulty.
If so, make sure there were no DTC's before swapping the ECM with a
new one, and then check the vehicle again. If DTC's were found, examine
this first before swapping ECM.
|
4. |
RE-TEST THE ORIGINAL ECM: Install the original ECM (may be broken)
into a known-good vehicle and check the vehicle. If the problem occurs
again, replace the original ECM with a new one. If problem does not
occur, this is intermittent problem (Refer to “Intermittent Problem
Inspection Procedure” in Basic Inspection Procedure).
|
Shift Lever. Components and Components Location
Components
1. Shift lever knob & boot assembly
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Components and Components Location
Component Location
1. Start Stop Button(SSB)
2. FOB key
3. Smart key unit
4. Interior antenna 1
5. Interior antenna 2
6. Tailgate antenna
7. Door handle & ...
How to use this manual
We want to help you get the greatest possible driving experience from your vehicle.
Your Owner’s Manual can assist you in many ways. We strongly recommend that you
read the entire manual. In ord ...