1. Turn the ignition switch and all other switches off.
2. Remove the fuse
panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace
it if it is blown. To remove or insert the fuse, use the fuse puller in the engine
compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure
it fits tightly in the clips. If it fits loosely, consult an authorized HYUNDAI
dealer.
CAUTION
After checking the fuse panel in the engine compartment, securely install the fuse panel cover. If not, electrical failures may occur from water contact.
Multi fuse
If the multi fuse is blown, it must be removed as follows:
1. Remove the fuse panel in the engine compartment.
2. Remove the nuts shown
in the picture above.
3. Replace the fuse with a new one of the same rating.
4. Reinstall in the reverse order of removal.
✽ NOTICE
If the main or multi fuse is blown, consult an authorized HYUNDAI dealer.
Tires and wheels
CAUTION
When replacing tires, use the same size originally supplied with the vehicle.
Using tires of a different size can damage the related parts or make it work irregularly. ...
Input Speed Sensor 2 > Description and Operation
Description
The input shaft speed sensor is important in that it detects the input
shaft RPM and sends this information to the TCM. It provides important input
information for electric contr ...
Tire. Repair procedures
•
Using tires and wheel other than the recommended sizes
could cause unusual handling charact ...