Hyundai Veloster: Driveshaft and axle

Back-up Lamp Switch. Repair procedures

Inspection 1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup la ...

General Information

...

See also:

Changing the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. CALIFORNIA PROPOSITION 65 WARNING Engine oil contains c ...

Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be he ...

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output ...