Hyundai Veloster: Dimensions Projected
Hyundai Veloster 2011-2017 Service Manual / General Information / Dimensions Projected
Hyundai Veloster 2011-2017 Service Manual / General Information / Dimensions Projected
| 1. |
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, measure
it by lengthening one of two probes as long as the different value in
height of the two surface.
|
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Measuring Actual Dimensions
1.
These dimensions indicate the actual linear distance between measurement
points, and are used as the reference dimensions when a tracking gauge
is used for measurem ...
See also:
ETC (Electronic Throttle Control) System. Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle ...
Clutch Pedal. Repair procedures
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin pla ...
Repair procedures
Troubleshooting Starter Circuit
The battery must be in good condition and fully charged.
1.
Remove ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
В© 2011-2025 Copyright www.hvmanual.com