Hyundai Veloster: Description and Operation

The charging system includes a battery, an alternator with a built-in regulator, and the charging indicator light and wire.

The Alternator has built-in diodes, each rectifying AC current to DC current.

DC current appears at alternator "B" terminal. The charging voltage of this alternator is regulated by the battery voltage detection system (or ECM - with AMS).

The main components of the alternator are the rotor, stator, rectifier, capacitor, brushes, bearings and V-ribbed belt pulley (or OAD : Overrunning Alternator Decoupler). The brush holder contains a built-in electronic voltage regulator.

Alternator management system controls the charging voltage set point in order to improve fuel economy, manage alternator load under various operating conditions, keep the battery charged, and protect the battery from over-charging. ECM controls generating voltage by duty cycle (charging control, discharging control, normal control) based on the battery conditions and vehicle operating conditions.

The system lowers the charging rate when accelerating. Lowering the charging rate will allow more engine power for accelerating.

The system increases the charging rate when decelerating. The system uses the unused power of the decelerating engine and increases the charging rate.

Charging System

...

Repair procedures

On-vehicle Inspection • Check that the battery cables are connected to the correct terminals ...

See also:

If the engine will not start
If engine doesn't turn over or turns over slowly 1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check th ...

Gear Actuator Motor > Repair procedures
Inspection 1. Turn off the ignition switch. 2. Disconnect the gear actuator motor connector. 3. Measure the ...

Knock Sensor (KS). Schematic Diagrams
Circuit Diagram ...