Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the OCV connector.
|
3. |
Measure resistance between the OCV terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the CVVT oil control valve connector (A).
|
3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
Installation
|
|
1. |
Installation is reverse of removal.
|
Room lamp
• ON (1): In the ON position, the light stays on at all times.
• DOOR (2) : In the DOOR position, the light comes on when any door is opened
regardless of the ignition switch position. When d ...
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons
or turning knob(s) other than the AUTO button. In this case, the system works sequentially
according to the order of b ...
Repair procedures
Removal
Back View Camera
1.
Disconnect the negative(-) battery terminal.
2.
Remove the tailgate outside handle assembly.
(Refer to ...