Hyundai Veloster Manuals

Hyundai Veloster: Crankshaft Position Sensor (CKPS). Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: Crankshaft Position Sensor (CKPS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS). Repair procedures

Inspection

1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS). Schematic Diagrams
Circuit Diagram [NON - ISG] [ISG] ...

Camshaft Position Sensor (CMPS). Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the ...

See also:

Description and Operation
Cruise Control The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, ac ...

Engine Coolant Temperature Sensor (ECTS). Specifications
Specification Temperature Resistance (kΩ) °C °F -40 -40 48.14 -20 -4 ...

Power Seat Motor. Repair procedures
Inspection Power seat motor 1. Remove the seat and Lumbar support motor (A) connectors. 2. With the battery connected dire ...

Categories


© 2011-2024 Copyright www.hvmanual.com