Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop because of CKPS signal missing.
This sensor is installed in ladder frame and generates alternating current
by magnetic flux field which is made by the sensor and the target wheel when
the engine rotates. The target wheel consists of 58 slots and 2 missing slots
on 360 CA (Crank Angle). In case of ISG, the ISG function get reliable information
about crank shaft position during all modes of operation. The CKPS in ISG function
ensures short restarting time for engine and efficient combustion.
Operation
Two separate differential channels for speed and direction information
respectively.
Phase separation of the 2 channels delivers information on rotation direction.
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immers ...
Specification
[ISG]
Item
Specification
Coil Resistance (Ω)
774 ~ 946 [20°C (68°F)]
...
See also:
Rear view camera
The rearview camera will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicl ...
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be he ...