Inspection
Clutch Pedal Inspection |
1. |
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin play (measured at
the face of the pedal pad.)
|
Ignition Lock Switch Inspection |
1. |
Disconnect 2P-connector from a ignition lock switch.
|
2. |
Disconnect the ignition lock switch. (if you can install a tester
with the switch fixed, this step can be omissible)
|
3. |
Check for continuity between terminals. (refer to the table below)
|
Removal
|
1. |
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
|
2. |
Disconnect the clutch tube (B) and reservoir hose (A) from the
clutch master cylinder.
|
3. |
Disconnect the push rod from the master cylinder by removing the
snap pin (A) and washer (B).
|
4. |
Remove the clutch pedal mounting bolt (A) and nuts (B-2ea).
|
5. |
Disconnect the ignition lock switch connector (C) and clutch switch
connector (B).
|
6. |
Remove the clutch pedal and the master cylinder assembly together.
|
Installation
1. |
Installation is in reverse order of removal.
|
Inhibitor Switch > Repair procedures
Inspection
1.
Inspect for loosened connectors, faulty connections, bends, corrosion,
contamination, deformation, or damage.
2.
Disconnec ...
Front Washer Motor. Repair procedures
Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
...
Components and Components Location
Component Location
1. Hood switch
2. Burglar horn
3. IPM (BCM) and RF antenna
4. Key warning switch
5. Front door switch
6. Front door lock actuator & sw ...