Removal
1. |
Remove the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)
|
2. |
Remove the clutch cover bolts. Be careful not to be bent ortwist
bolts. Loosen bolts in diagonal directions.
|
Inspection
1. |
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
|
2. |
Check the clutch cover and disc surface for wear or cracks.
|
3. |
Check the clutch disc lining for slipping or oil marks.
|
4. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Installation
If reinstalling used cover, the cover should be installed with
its clutch disc as a set.
|
1. |
Replace a clutch cover and disc as a set.
|
2. |
Apply grease on a disc spline part and transmission input shaft
spline part as required.
|
3. |
The 'T/M SIDE' marked surface should face the transmission .
|
4. |
Install the clutch disc and the cover with SST(A : 09411-1P000).
|
5. |
Install the clutch cover bolts. Not to be bent or twisted, Tighten
them in diagonal directions.
|
6. |
Install the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)
|
Vanity mirror lamp
Push the switch to turn the light on or off.
• : The lamp will turn on if this
button is pressed. • : The lamp will
turn off if this button is pressed.
CAUTION - Vanity mirror lamp (if equ ...
Troubleshooting
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of theproblem. The numbers
indicate the priority of the likecause of the problem. Check each p ...
Components and Components Location
Component Location
1. Start Stop Button(SSB)
2. FOB key
3. Smart key unit
4. Interior antenna 1
5. Interior antenna 2
6. Tailgate antenna
7. Door handle & ...