Inspection
1. |
Turn off the ignition switch.
|
2. |
Disconnect the clutch motor connector.
|
3. |
Measure the resistance on the clutch motor terminal.
|
4. |
Refer to the specifications and check that the measured resistance
is as specified.
|
Removal
1. |
Remove the following parts first:
|
2. |
Disconnect the clutch actuator motor connector (A).
|
3. |
Loosen the mounting screw, and then remove the clutch actuator
motor (A).
|
Installation
1. |
Installation is the reverse of removal.
|
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation. Your Hyundai deale ...
Schematic Diagrams
MDPS Circuit Diagram
Harness Connector
Type
Pin NO
Description
Battery
1
Battery +
2
B ...