1. Be sure the vehicle is on level ground.
2. Start the engine and allow it
to reach normal operating temperature.
3. Turn the engine off and wait for a few
minutes (about 5 minutes) for the oil to return to the oil pan.
4. Pull the dipstick
out, wipe it clean, and re-insert it fully.
WARNING - Radiator hose
Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Use only the specified engine oil. (Refer to “Recommended lubricants and capacities” in section 8.)
Rear view camera
The rearview camera will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicl ...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Sunshade
The sunshade will automatically open, when you push the sunroof control lever
backward to the first detent and then release it.
The sunshade will automatically close, when you push the sunroof co ...