Hyundai Veloster: Check Fuses

A blade type fuse test taps provided to allow checking the fuse itself without removing if from the fuse box. The fuse is good if the test lamp lights up when one lead is connected to the test taps (one at a time) and the other lead is grounded. (Turn the ignition switch so that the fuse circuit becomes operative)

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

Servicing The Electrical System

1. Prior to servicing the electrical system, be sure to turn off the ignition switch and disconnect the battery ground cable. ...

See also:

Schematic Diagrams
MDPS Circuit Diagram Harness Connector Type Pin NO Description Battery 1 Battery + 2 B ...

Components and Components Location
Components 1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & G sensor 5. Steering angle sensor 6. ABS Warning lamp 7 ...

Side Airbag (SAB) Module. Repair procedures
Removal The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airba ...