Hyundai Veloster Manuals

Hyundai Veloster: Camshaft Position Sensor (CMPS). Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: Camshaft Position Sensor (CMPS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures

Inspection

1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”

Removal

•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the hanger and the protector.
4.
Remove the installation bolt (B), and then remove the sensor.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Camshaft Position Sensor (CMPS). Schematic Diagrams
Circuit Diagram ...

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...

See also:

Description and Operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp fo ...

Components and Components Location
Component Location 1. Driver power window main switch 2. Passenger power window switch 3. Front window motor 4. Rear window motor 5. Rear window switch ...

Specifications
Specifications Item Specification Type Electronic Power Steering System Steering gear Type Rack & Pini ...

Categories


© 2011-2024 Copyright www.hvmanual.com