Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
(Refer to the Body group - "Crash Pad")
|
3. |
Disconnect the stop lamp switch connector (A).
|
4. |
Remove the brake pedal member mounting bolt (A).
|
5. |
Remove the snap pin (A) and clevis pin (B).
|
6. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Inspection
1. |
Check the bushing for wear.
|
2. |
Check the brake pedal for bending or twisting.
|
3. |
Check the brake pedal return spring for damage.
|
4. |
Check the stop lamp switch.
|
Installation
1. |
Pre-tighten the bracket fixing bolt (A) in dash panel.
|
2. |
Install the brake booster and brake pedal member fixing nuts (A)
securely.
|
3. |
Tighten the bolt (A) securely in dash panel.
|
4. |
Install the snap pin (A) and clevis pin (B).
|
5. |
Install the stop lamp switch securely.
|
6. |
Connect the stop lamp switch connector (A).
|
7. |
Adjust the brake pedal height and free play.
|
8. |
Check the brake pedal operation after installing the brake pedal.
|
9. |
Install the crash pad lower panel.
|
10. |
Reconnect the negative (-) battery cable.
|
Adjustment
Stop lamp switch clearance adjustment |
1. |
Disconnect the stop lamp switch connector (A).
|
2. |
Pull the locking plate (A) as indicated by the arrow.
|
3. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
4. |
Fix the brake pedal arm and insert fully the stop lamp switch
as hiding contact part.
|
5. |
After inserting, turn the stop switch (A) 45° clockwise, and then
assemble locking plate (B) by pushing.
|
6. |
Confirm the gap between stop lamp switch and bracket.
|
7. |
Connect the stop lamp switch connector.
|
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be he ...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between th ...
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the
shift lever to the P(Park) pos ...