Hyundai Veloster: Back view camera System

Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to the BD group - "Cra ...

Description and Operation

Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows beh ...

See also:

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform ...

Side Impact Sensor (SIS). Components and Components Location
Components ...