Removal
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel (A).
|
3. |
Disconnect the connectors (A) from center fascia panel.
|
4. |
Remove the AVN head unit assembly (A), after loosening the 4 screws.
|
5. |
Disconnect the AVN head unit connectors and antenna cables (A),
then remove the AVN head unit.
|
1. |
Remover the assistant seat.
(Refer to the BD group - "Seat - Front seat")
|
2. |
Disconnect the external amplifier connector.
|
3. |
Loosen a bolt and 3 nuts, then remove the external amplifier (A).
|
Installation
1. |
Connect the AVN head unit connectors and cables.
|
2. |
Install the AVN head unit.
|
3. |
Install the center fascia upper panel.
|
4. |
Connect the negative (-) battery terminal.
|
1. |
Connect the connector and install the external amplifier.
|
2. |
Install the assistant seat.
|
High Pressure Fuel Pump. Repair procedures
Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be in ...
Crankshaft Position Sensor (CKPS). Description and Operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the eng ...
Description and Operation
Description
The Dual Clutch Transmission (DCT) control system measures required data
to identify the state of the control target and computes the appropriate compensation
value if adjustment ...