Hyundai Veloster Manuals

Hyundai Veloster: Antenna Coil. Repair procedures - Immobilizer System - Body Electrical SystemHyundai Veloster: Antenna Coil. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Disconnect the 6P connector (B) after loosening the screw and then remove the antenna coil (A).


Installation

1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.

Immobilizer Control Unit. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad& ...

Rear Parking Assist System
...

See also:

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output ...

Electrical System
1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting con ...

Description and Operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp fo ...

Categories

В© 2011-2026 Copyright www.hvmanual.com