Hyundai Veloster Manuals

Hyundai Veloster: Alignment. Repair procedures - Tires/Wheels - Suspension SystemHyundai Veloster: Alignment. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Suspension System / Tires/Wheels / Alignment. Repair procedures

Front Wheel Alignment

• When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead.
• Prior to inspection, make sure that the front suspension and steering system are in normal operating condition and that the tires are inflated to the specified pressure.
• You have to ASP (Absolute Steering Position) calibration after alignment adjusting.

Toe

B - A. 0: Toe in (+)
B - A < 0: Toe out (-)

Toe Adjustment

1.
Loosen the tie rod end lock nut.
2.
Remove the bellows clip to prevent the bellows from being twisted.
3.
Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.
Toe:
Total : 0.1° ± 0.2°
Individual : 0..05° ± 0.1°

4.
When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.
Tightening torque :
23.5 ~ 33.3N.m (2.4 ~ 3.4kgf.m, 17.4 ~ 24.6lb-ft)

Camber and Caster

Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.
Camber angle : -0.5° ± 0.5°
Caster angle : 4.22° ± 0.5°

Rear Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.

Toe

B - A. 0: Toe in (+)
B - A < 0: Toe out (-)
Toe is pre-set at the factory, so it does not need to be adjusted. If the toe is not within the standard value, replace or repair the damaged parts and then inspect again.
Toe:
Total : 0.5°(+0.5°/ -0.4°)
Individual : 0.25°(+0.25°/ -0.2°)

Camber

Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.
Camber : -1.5°±0.5°

Tires/Wheels
...

Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

See also:

Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided i ...

Front Washer Motor. Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram ...

Categories


© 2011-2024 Copyright www.hvmanual.com