Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Turn the ignition switch ON.
|
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it
to reach normal operating temperature. 3. Turn the engine off and wait for a few
minutes (about 5 minutes) for the oil ...
Rear Seat. Components and
Components Location
Components
1. Headrest [RH]
2. Headrest guide [RH]
3. Rear seat back cover [RH]
4. Rear seat cushion cover [RH]
5. Cup holder panel assembly
6. Headrest [LH]
7. H ...
Front Hub / Knuckle. Components and
Components Location
Components
1. Drive shaft caulking nut
2. Brake disc
3. Hub
4. Wheel bearing
6. Snap ring
7. Dust cover
8. Knuckle
9. Drive shaft
...