Hyundai Veloster: Accelerator Position Sensor (APS). Description and Operation

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Rail Pressure Sensor (RPS). Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Accelerator Position Sensor (APS). Specifications

Specification Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 ...

See also:

MTS Antenna. Repair procedures
Removal Roof Antenna (GPS) 1. Remove the rear roof trim. (Refer to the BD group - "Roof trim") 2. Disconnect the cables ( ...

Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle. Do not race the ...

Components and Components Location
Component Location 1. Rear wiper motor assembly 2. Rear wiper motor grommet 3. Rear wiper arm & blade 4. Nut ...